Fieldmann FVC 4001 EK User Manual download pdf (Page 5)

USER‘S MANUALSUBMERSIBLE PUMP

ENMachine description and included contents | Putting into operation

Supplied contents

Submersible pump

Operating instructions

Hose connection with pump tube bend

If there are parts missing or they are damaged, please contact the vendor from whom you bought

the machine.

3. PUTTING INTO OPERATION

Installation

Submersible pumps are installed as follows:

in a permanent position with a rigid pipe.

in a permanent position with a ﬂ exible pipe.

You should never install the pump by hanging it on the outlet hose or power cord without

additional support.

The submersible pump must be hung on a holder, or it must be placed on the bottom of the

tank.

For the pump to function correctly the bottom part of the tank must be protected against any

kind of dirt (applies to clean water pumps) and against any larger residue (for the size of dirty

material see the technical speciﬁ cations of the individual models).

If the water level declines too much, any residue in the pumping pit will quickly dry out and

prevent the pump from starting again. It is therefore essential to regularly inspect the

submersible pump (by starting it).

The ﬂ oat is set up in such a way that the pump may be started immediately.

After carefully reading these instructions you can prepare your pump for operation, however, keep

the following points in mind:

Check that the pump is standing on the bottom of the tank.

Check that the outlet hose has been attached correctly.

Check that the electrical connection is 230 V

50 Hz.

Check that the power socket is in good condition.

Ensure that the moisture from the water can never get to the electrical power source.

Prevent the pump from running empty.

Before putting the pump into operation, please check the following points:

The switching ﬂ oat is installed in such a way that it is possible to reach the activation level

or the shut off level with only a small amount of force. After checking this installation, place

the pump into a tank with water and carefully lift the switching ﬂ oat by hand and then put it

down again. During this activity watch that the pump has started and then turned itself off.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Fieldmann FVC 4001 EK User Manual Page 5